Tools

This tie rod tool spreads the tie rod adjusting sleeve foreasier adjustment. You can use these tools with a brackerbar for additional power. With 1/2" drives.

For VGB 610-On-The-Car Lathe---3 cut edges---positive rake6 bits per pack.

Four position feature and 360° rotation lets you gripthe sleeve properly, even with limited access. Fits mostpassenger cars & light trucks.

For Hunter Model # 201,205---Hunter Part # V302-07-167---12 cut edges ---- negative rake10 bits per pack.

Torque stick specification chart

This special 10 point socket is needed when removing the O.Erear lower control arm on new 2001 to 2006 Honda Civics,2003 and up Elements, 2002 to 2006 CRV's and 2002 to 2007Acura RSX's. Included with part numbers 69300 adn 69400.This Part...

The Honda Accord and Acura TSX Rear Adjustable Trailing Armis an ideal replacement for a damaged OE component,Additionally, it will provide ±1" set-back/wheel baseadjustment. This arm is necessary to to correct set-backchanges that the 67545 adjustable...

Our patented thrust alignment plate will allow forcorrections of setback and thrust angle on most vehicleswith rear leaf springs. Installation is made by looseningthe U-bolts holding the leaf spring to the axle, installingthe alignment plate between the a

Our patented thrust alignment plate will allow forcorrections of setback and thrust angle on most vehicleswith rear leaf springs. Installation is made by looseningthe U-bolts holding the leaf spring to the axle, installingthe alignment plate between the a

SPC Performance HAMMER FOR 499

SPC Performance JAM NUT FOR 499

SPC Performance CENTER ROD ASSEMBLE

SPC Performance YOKE FOR 499

Flange type axle puller can be used as a regular wheelpuller or hub puller, as well as a flange type puller.The bolt circle range is from 4-1/2" to 5-1/2", whichcovers all cars and small trucks with flange type axles.The four slots allow this tool to be u

SPC Performance JAM NUT FOR 498