Wastegate Springs

MACH 2 ATMO UPGRADE KIT TO CONVERT MACH 2?FROM RECIRC TO ATMO VENTING BOV, WITH TRUMPET, SPRING AND PLUG. Harder spring supplied in this kit, as the valve needs to remain closed at idle when venting to atmo, to prevent stalling/backfiring.

The 5701 can be used in place of the standard trumpet on GFB valves (Part numbers T9003 & T9503), and will make a whistling sound. However, it is necessary to run the valve so that all (or most) of the air vents through the trumpet ? Respons valves will...

Go Fast Bits Hose Plug

The 5702 can be used in place of the standard trumpet on all GFB valves, and will make the whistling sound more readily than the 5701 (high boost and RPM is required to get the whistle from a 5701), and at a slightly higher pitch.? Like the 5701 however,...

Go Fast Bits Hose Plug

A G-force/D-force Wiring Loom Replacement Suits all Electronic Boost Controllers

Replacement for all boost controllers, also can be used for any aftermarket ECU's

The latest iteration of GFB's feature-packed electronic boost controller now has the ability to monitor and display your engine's air/fuel ratio in either Lambda or AFR. By connecting the analogue output of most wideband O2 controllers (i.e. Innovate...

It is important to note that the Atomic does NOT use a "ball-and-spring" system like others on the market, for very good reason. The ball-and-spring system is an attempt to increase the boost rise rate by preventing pressure from reaching the wastegate...

It?s common knowledge that some engines with vacuum operated ECU controlled VNT/VGT turbos suffer erratic boost behaviour, to the point where turbo or engine failures can occur, even on completely stock vehicles. The V2 takes over from the factory ECU...