Tools

Four position feature and 360° rotation lets you gripthe sleeve properly, even with limited access. Fits mostpassenger cars & light trucks.

For Hunter Model # 201,205---Hunter Part # V302-07-167---12 cut edges ---- negative rake10 bits per pack.

Torque stick specification chart

This special 10 point socket is needed when removing the O.Erear lower control arm on new 2001 to 2006 Honda Civics,2003 and up Elements, 2002 to 2006 CRV's and 2002 to 2007Acura RSX's. Included with part numbers 69300 adn 69400.This Part...

The Honda Accord and Acura TSX Rear Adjustable Trailing Armis an ideal replacement for a damaged OE component,Additionally, it will provide ±1" set-back/wheel baseadjustment. This arm is necessary to to correct set-backchanges that the 67545 adjustable...

Easily and quickly remove and install rear trailing armbushing in as little as 15 minutes per side vs. the factory"book" time of 1.8 hours per side. No need to remove thetrailing arm from the vehicle or use a hydraulic press.This Part...

Radial Run-Out Gauge is an out of round condition in whichthe radius of the wheel or tire is not consistend from thewheel center to any point on the rim or the tread. Tire andwheel radial run-out are often factors in troubleshootingride and handling and i

This angle gauge is an easy, accurate way for measuringframe & drive shaft angles. An ideal tool to ensure thedrive line angle is still within specification for raised &lowered vehicles.----------------------Alignment equipment manufacturers are using fra

Our patented thrust alignment plate will allow forcorrections of setback and thrust angle on most vehicleswith rear leaf springs. Installation is made by looseningthe U-bolts holding the leaf spring to the axle, installingthe alignment plate between the a

Our patented thrust alignment plate will allow forcorrections of setback and thrust angle on most vehicleswith rear leaf springs. Installation is made by looseningthe U-bolts holding the leaf spring to the axle, installingthe alignment plate between the a

SPC Performance HAMMER FOR 499

SPC Performance JAM NUT FOR 499

SPC Performance CENTER ROD ASSEMBLE

SPC Performance YOKE FOR 499

Flange type axle puller can be used as a regular wheelpuller or hub puller, as well as a flange type puller.The bolt circle range is from 4-1/2" to 5-1/2", whichcovers all cars and small trucks with flange type axles.The four slots allow this tool to be u